From the valley floor to lake level

Our home base and the densest part of our service map.

Nevada City's historic district is a genuinely different HVAC problem: designated historic homes, tight lots, limited equipment locations, minimal or no existing duct paths, and a real premium on keeping exterior changes discreet.

Lower and warmer than the ridge towns, Penn Valley sees a heavier cooling load alongside its heating season, and many properties sit on acreage with propane rather than natural gas.

Largely rural parcels with long driveways, well and propane service, and outbuildings that owners want conditioned — shops, studios and guest quarters.

Alta Sierra's elevation and heavy tree canopy give it a longer, colder heating season than the towns just below it, and outdoor units here sit under pine and oak litter that fouls coils fast.

A planned lakeside community with consistent housing vintages, HOA considerations for exterior equipment placement, and a meaningful share of seasonal and second homes.

Truckee is a true cold-climate design problem and the most demanding part of our map.

At lake level on the west shore, Tahoe City combines a severe heating season with a high proportion of vacation rentals and second homes.

North-shore Kings Beach shares Tahoe's severe winter with a dense mix of older cabins, small multi-unit buildings and short-term rentals.

Down the hill in Placer County, Auburn's summers run hot enough that cooling capacity and duct performance in unconditioned attics drive most of our work — the opposite emphasis from the ridge towns.

Colfax sits at a similar elevation to Grass Valley along the I-80 corridor, with a comparable balance of heating and cooling load and a lot of rural parcels on propane.

Valley-floor Rocklin is a cooling-dominated climate with mostly newer tract construction and accessible attic duct runs.